Adhere 210cc is packaged in an industry standard cartridge and holds 30% more material than prior models, giving you more material for your money. Fast-setting urethane adhesive designed to bond steel, aluminum and urethane shoes to the hoof and to fabricate large and small hoof wall repairs.

For use as adhesive
4 week average for glue-on urethane shoes
Initial set time of 1 minute and final cure time of 6 minutes
Perfect for most every hoof repair application
Adhere sets hard with a superior bond, but maintains the flexibility necessary at the quarters and heels to allow the natural movement of the hoof

PLEASE NOTE BEFORE APPLYING PRODUCT
Vettec products are best used between 65° and 85° F (18° to 29° C). Temperature will affect the set time. See Cold & Hot Conditions below.
Areas of wetness or bleeding should not be covered. Once healed, commence using products.
Adhere™ can be applied with the shoe on or off but will bond to the shoe. A coating of oil or petroleum jelly to the top of shoe will prevent this from occurring. Take care not to get any on the area of the hoof being repaired.
Product may not bond to hooves that have been heavily treated with products containing: oils, grease, pine tar, etc. In these instances, a light denatured alcohol scrub and drying should be performed to ensure adhesion.
The following procedures are best-accomplished wearing latex or rubber gloves.
Do not burn or "Hot Shoe" this product.
Use only Vettec mixing tips.